Improve efficiency
- Monitor and control device via long range DMR, reduce site visit
- Design, manage and maintain a single network for voice and data
- Voice and message dispatching / route inspection / emergency communication
![[Translate to Polnisch:] Hytera DTM-6000 SCADA Datenmodem](fileadmin/user_upload/produkte/Fotoheader/DTM_6000_Produktseitenheader.jpg "[Translate to Polnisch:] Hytera DTM-6000 SCADA Datenmodem")
Hytera DTM-6000 SCADA data modem
Powerful and flexible. For every scenario.
Opis produktu
The DTM-6000 is a dedicated data modem, providing wide coverage data communications. The flexibly connectable RTUs allow supervising and controlling equipment like sensors, meters and Programmable Logic Controllers (PLC). Thanks to the high output power the concerned areas can be covered, ideally just with the existing DMR base stations. Flexible installation variants (wall-mounted, rail-mounted, flat-mounted) help to design your sites according your requirements and wishes.
Security
- AES-256 bit data encryption over the air
- End to end data encryption
- Key management through web page configuration
- Registration and authentication for data modem
- User name and password protection for WiFi access
- Stun and revive to disable modem
Flexible interfaces
- Two RS232/RS485 serial interfaces for legacy equipment connection
- Two 10/100 Mbps ethernet connection
Standard based interface protocol
- Standard SCADA protocol: IEC60870-5-101 and 104, DNP3.0 over IP/serial, Modbus
- Network time protocol (NTP)
Applications
- SCADA for power/utilities industry
- SCADA for oil & gas industry (Mining and pipeline transportation)
- SCADA for control of irrigators
Data services
- Packet data over traffic channels for telemetry, SCADA and customer specific applications
- Dedicated data channel ensures capacity
- Transparent IP data interface operation
- Short data messages, location, status and text
Remote site monitoring
- Temperature
- Transmitting power
- Input voltage
- Telemetry equipment status
- 0ver The Air (OTA) configuration
- Wi-Fi access point for remote access, re-configuration or upgrades
Funkcje
Dane techniczne
General data
| Frequency range |
VHF: 136 – 174 MHz UHF: 400 – 470 MHz |
| Operation voltage |
Input voltage: 10 - 30 VDC |
| Dimensions (L x W x H) |
199.5 x 186 x 58 mm |
| Weight |
≤ 2.5 kg |
| Installation |
Wall-mounted Rail-mounted Flat-mounted |
| Packet data |
½ Rate, ¾ Rate |
| Air interface standard |
DMR: ETSI TS 102 361 |
| Certification |
CE, FCC |
Transmitter
| Transmitting power |
1-25 W (adjustable) |
| Adjacent channel selectivity |
60 dB @ 12.5 KHz |
| Noise cancellation |
40 dB @12.5 kHz |
| Weight |
≤ 2.5 kg |
Environmental conditions
| Operating temperature range |
-30 °C - +60 °C |
| Storage temperature range |
-40 °C - +70 °C |
| ESD |
IEC 61000-4-2 (level 4) ± 8 kV (contact) ± 15 kV (air) |
| Operating humidity |
<95 %（non-condensing） |
| Shock and vibrations |
1.5 m anti-dropping with packaging, off working state |
| MTBF |
≥ 30.000 hours |
| IP rating |
IP40 |
Receiver
| Intermodulation rejection (ETSI) |
70 dB |
| Spurious response rejection (DMR) (ETS 300-113) |
70 dB |
| Ethernet |
0.3 μV / BER 5 % |
| Noise cancellation |
40 dB @ 12.5 kHz |
| Conducted spurious emission |
< - 57 dBm |
Interfaces
| Serial COM1 / COM2 |
RS232, RS485 DB9 |
| 2x Ethernet |
10/100 M Base T, RJ45 |
| Antenna |
TNC Female |
| Antenna (WiFi) |
SMA |
Właściwości oznaczone symbolem * będą dostępne w przyszłych wersjach produktu.
Wszystkie informacje techniczne zostały przetestowane zgodnie z odpowiednimi standardami. Z powodu stałego rozwoju produktu zastrzega się możliwość wprowadzania zmian.
Zakres dostawy
- Hytera DTM-6000 SCADA Data Modem
- Manual
